top of page

Tune ups

Bow Tune Ups/Tune Up Plus 

              As needed the Tech will perform the following steps when Tuning a customer’s bow. 

​

  • Ensure draw length and draw stop are set properly for the customer if it is required 

  • Ensure bow is statically timed 

  • Ensure rest is secure and set for centershot and elevation 

  • Put on a new string loop and nockset 

  • Adjust poundage and draw length 

  • Adjust cams for cam lean 

  • Adjust cams for timing 

  • Re-level rest  

  • Ensure sight is in correct position, tightened and level (if type allows) 

  • Ensure stabilizer is tightened 

  • Ensure quiver is tightened 

  • Lube bolts/screws/etc. 

  • Wax String 

  • Inspect the following: (Customers are responsible for costs associated) 

  • General condition of the riser/limbs/cams/strings and cables/washers/spacers/nuts and bolts. 

All tie in components are covered during tune up; 

 (rest/peep/kisser/string loop/nockset/silencers) 

 

*TUNE UP PLUS IS ADDITIONAL COST AND WILL INCLUDE A PAPER TUNE OF THE BOW WHEN COMPLETE IF CUSTOMER PROVIDES AN ARROW 

Bow Set Ups  

​

**Bow set ups are included when bow is purchased from Archery World** 

​

 

The following aspects of a bow set up are covered when setting up a bow that has been purchased somewhere else. (exceptions: if parts need to be ordered to make the bow fit) 

  • As needed the Tech will perform the following steps when setting up a customer’s bow. 

  • Put Peep in the string and barrel tie  

  • Ensure draw length and draw stop are set properly for the customer 

  • Ensure bow is statically timed 

  • Ensure rest is secure and set for centershot and elevation 

  • Put on a new string loop and nockset 

  • Ensure Peak draw weight of the bow will hit factory specs 

  • Adjust poundage and draw length 

  • Adjust cams for cam lean 

  • Adjust cams for timing 

  • Re-level rest if needed 

  • Tie in rest if needed 

  • Ensure sight is in correct position, tightened and leveled (if type allows). 

  • Ensure stabilizer is tightened 

  • Ensure quiver is tightened 

  • Lube bolts/screws/etc. 

  • Adjust and do final tie of the peep after the customer is satisfied with peep height/position.  

bottom of page